Automatic COBRA Installationshandbuch PDF herunterladen (Seite 20)

Page 20

CODING TRANSMITTERS (continued)

PROGRAM A TRANSMITTER TO ACTIVATE VACATION MODE

1. Select Vacation mode using the LEARN button on the unit.

Display shows (L)ocked (FIG 24).

2. Within 10 seconds, momentarily press the required button on the

transmitter. The decimal point indicator on the display will

ﬂ ash and then stay on.

3. Re-press the same button again momentarily, the decimal point

indicator will ﬂ ash and then the display will show the memory

location number for that function ‘L xx’. The location number

xx will be the ﬁ rst free vacation location number in the

memory.

4. To test, when door in close position press and hold the transmitter

button set for vacation function for 5 seconds. The display

will ﬂ ash LC once the vacation mode is set. To reset vacation

function, press the same button for 5 seconds, the vacation mode will be unlocked.

COPY PRE-CODED TRANSMITTER FUNCTIONS TO A NEW TRANSMITTER

Using this method you do not need to have access the LEARN

button on the unit. However, you do need a transmitter that is

pre-coded to the Cobra® Overhead Garage Door Opener.

1. Using a small needle press the button through the Coding Hole

on a pre-coded transmitter (Fig 25) until the decimal point

illuminates and display shows (H)andheld (Fig 26).

2. Within 10 seconds press and hold the button on the new

transmitter for two seconds. ‘SEt’ (set) will ﬂ ash on the

display.

3. All functions that were programmed into the pre-coded

transmitter are now copied onto the new transmitter.

4. Test the new transmitter.

PROGRAM A TRANSMITTER TO OPERATE THE ALARM

FUNCTION

1. Select Alarm mode using the LEARN button on the unit. Display

shows (A)larm (Fig 27).

2. Within 10 seconds, momentarily press the required button on the

transmitter. The decimal point indicator on the display will

ﬂ ash and then stay on.

3. Re-press the same button again momentarily, the decimal point

indicator will ﬂ ash and then the display will show the memory

location number for that function ‘Axx’. The location number

xx will be the ﬁ rst free location number in the memory.

4. Press the transmitter button to test if it operates the alarm.

PLEASE NOTE: Note the Alarm output (ALM) shares its function

with the door status output. If there are transmitter codes

memorised for the security alarm this output will not function as

a door status output.

/($51 ,167$//

FIG 26

FIG 2

/($51 ,167$//

FIG 27

Coding Hole

/($51 ,167$//

FIG 24

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare

Automatic COBRA Installationshandbuch Seite 20

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Garagentor-Öffner Automatic COBRA